Attic Insulation in Toronto, ON
We air seal and insulate attic floors, half-storey attics and sloped ceilings in older Toronto homes.
Attic insulation in Toronto's century homes starts with working out what kind of attic the house actually has. In the Victorian and Edwardian semis we work in, you might find an open attic floor, a half-storey with knee walls, or a sloped ceiling with nothing above it at all, and each one gets insulated differently. Before any insulation goes in, we air seal around the chimney, the plumbing stacks and the other gaps, so warm, damp air stops leaking up into the attic.
Three kinds of attic space
Most older houses have one or more of three kinds of attic space. The quickest way to tell which you have is to open the attic hatch and look at the shape of the top-floor rooms. A flat ceiling with a hatch above it means an open floor. Short walls and a slanted ceiling mean a half-storey. If the slope runs all the way to the peak and there's no hatch, there is no attic over that part of the house.
Plenty of semis have two of these at once. That's why, at Premier Insulation Toronto, we look at every house before we quote.
Open attic floors
An open attic floor is the space you see from the hatch: ceiling joists running across, the back of the plaster or drywall below, and room to move, even if it's on hands and knees. Once the air sealing is done, we blow loose-fill insulation across the floor and fit baffles at the eaves so the insulation never blocks the air coming in from the soffits. If the attic is barely big enough to crawl into, we plan the hose route and the sealing order before anyone goes up.
Half-storey attics and knee walls
You can spot a half-storey attic from the top-floor rooms: short walls, a sloped section of ceiling and a small flat ceiling near the peak. The short walls are knee walls. Behind them is a low triangle of unheated space, often used for storage. Insulating a half-storey attic means covering the knee wall, the floor behind it and the slope above the room, because heat gets out through whichever part is skipped.
Sloped ceilings with no attic above
A sloped ceiling with no attic above means the finished ceiling follows the roof rafters and there's nothing to stand on behind it. With no floor to blow insulation onto, the work happens inside the rafter bays, either from the room side or from the roof side. Spray foam suits these shallow cavities because it gets the most out of a thin space.
Sealing the attic floor comes first
Sealing the attic floor comes before any insulation because warm air rising from the house carries heat and moisture through every gap in the ceiling. Insulation slows heat, but it does little to stop air moving through it. In winter, when that warm, damp air reaches the cold underside of the roof, the moisture can condense on the sheathing and the roofing nails.
We close the gaps with spray foam and sealant, one spot at a time across the floor, before a single bag of insulation goes up. On an attic floor, this is our list:
- Chimney: we close the gap between a masonry chimney and the wood framing with sheet metal and high-temperature sealant. Ordinary foam must never touch a chimney.
- Plumbing stack: the hole around the vent pipe is often cut much bigger than the pipe. We close it with foam or a flexible collar so the pipe can still move.
- Wiring holes: we foam every hole drilled through a top plate for a cable, and the gaps around ceiling light boxes too.
- Top plates: we seal the joint where each interior wall meets the attic floor. In balloon-framed houses, wall cavities can run open from the basement right up into the attic, so we block the tops of them.
- Attic hatch: the frame gets weatherstripping and the back of the hatch gets a piece of rigid insulation, so it closes tight and stops being the weakest spot in the ceiling.
- Bathroom fan housings and ceiling fixtures: we seal them from above where the housing allows it, and check that the fan duct vents outdoors and not into the attic.
Knee walls and the cold top-floor rooms
If your top floor has short walls with storage space behind them, there are two ways to insulate it, and the right one depends on what you want that space to be. One is knee wall insulation: we insulate and air seal the knee wall itself, then insulate and seal the floor of the space behind it, which leaves the storage area outside the warm part of the house. The other is to move the insulation up to the roofline and bring the storage space inside.
What usually keeps these rooms cold in winter and hot in summer is the open floor behind the knee wall. Outside air runs straight under the room above, so even a well-insulated knee wall leaves you with a cold floor.
Foam works well in the tight spots, like the joist ends behind a knee wall and the narrow slope between the knee wall and the flat ceiling. If the insulation moves up to the rafters, the job becomes roof insulation, and we check the roof deck and the venting before picking a material.
How much insulation an attic floor should have
A new house in Toronto needs R-60 on the attic floor in most cases and R-50 in the rest. Ontario's SB-12 sets R-60 as the minimum for a ceiling with attic space in Zone 1 under compliance packages A1, A2, A4 and A6, and R-50 under packages A3 and A5.
Toronto is in Zone 1. SB-1 gives the city 3520 heating degree-days, under the 5000 that divides Zone 1 from Zone 2.
For an existing attic, treat those figures as a reference point. The code writes them for new houses. An older attic gets judged on what's already up there, how much height there is above the ceiling and how well the floor has been sealed. On an open floor we build up the depth with loose-fill insulation, which settles around joists, wiring and blocking without the gaps that cut batts tend to leave.
Old insulation, animals and vermiculite
Wet, flattened or rodent-damaged insulation comes out before new insulation goes in. Flattened insulation has lost the trapped air that does the work. Wet insulation means there's a leak to fix first. And insulation soiled by animals should never be buried under a fresh layer. Our old insulation removal work clears the attic floor down to the ceiling so the air sealing can be done properly.
If raccoons or other animals have been getting into the attic, a pest-control company needs to deal with them first. We start once the animals are gone and that work is done.
Vermiculite is a loose fill that looks like small, light pebbles, grey-brown or gold, poured between the joists in some older attics. If we find it, we stop work and leave it alone, and we recommend having a qualified lab or abatement firm test it before anything else happens in the attic.
Attic rebates
Home Renovation Savings offers an attic insulation rebate that doesn't require a home energy assessment, which makes it one of the simpler ones to use. Terms and eligibility apply, so check the current rules on the Home Renovation Savings site before the work is booked.
FAQ
Common questions about attic insulation
For an open attic floor, blown-in loose-fill is the best fit in most Canadian attics, laid over a sealed floor with baffles at the eaves. It fills in around joists and wiring and can be built up to whatever depth the attic needs. For sloped ceilings and the tight spots behind knee walls, where loose-fill won't stay put, spray foam is the better choice.
Yes. If the space behind the knee wall stays unheated, both the knee wall and the floor behind it need insulating and air sealing. Insulate only the wall and cold air keeps running under the room above. The alternative is to insulate along the roofline and treat the storage space as part of the house.
Yes, new insulation can go on top of old attic insulation as long as the old layer is dry and free of animal damage, and the floor beneath it has been air sealed first. Wet, flattened or rodent-damaged insulation should come out. If the old layer is vermiculite, nothing goes on top until a qualified lab or abatement firm has tested it.
No. Adding or replacing insulation doesn't need a City of Toronto building permit. The Zoning Bylaw still applies.
Get a Quote
Get a spray foam insulation quote in Toronto
Tell us the address and which part of the house bothers you, whether that is a cold top floor, a drafty basement or a ceiling with no attic above it. Phone or use the form. We'll set up a time to look at the house, then give you a written quote.