Our crew installs spray foam insulation in Old Toronto where one layer has to seal and insulate at once, and uses loose-fill or dense-pack where those will do the job. We are about 5 km from the middle of Old Toronto. Our pages for Old Toronto cover Dufferin, Little Portugal, Brockton, Christie, Parkdale, The Annex, Kensington Market, High Park, Runnymede, Church and Wellesley, Summerhill and Forest Hill.

The west end the city annexed

Old Toronto grew west by annexing the Town of Brockton in 1884 and the Town of Parkdale in 1889. By 1893 it had taken in properties west to Swansea, High Park among them. To the north, the city annexed Yorkville in 1883 and The Annex in 1887. Forest Hill and Swansea came in with the provincial reform of the metropolitan area in 1967.

For an insulation job, those dates matter for one reason. A house older than the annexations may have walls and a basement nobody has ever insulated. It may also have had work done in any decade since. You cannot tell which from the street, so we look at how the house is built before we quote foam.

Empty wall cavities usually mean wall insulation is a dense-pack job, not a foam job. Bare foundation walls and an open rim joist are different. That is where basement insulation with foam does something no other material can.

Our Old Toronto neighbourhood pages

The insulation work we do in Dufferin has its own page. So does Little Portugal, with the same part-by-part approach. Foam, loose-fill and dense-pack in Brockton are covered on that neighbourhood's page, and Christie has one too.

In Parkdale, we check each part of the house before we pick a material. Our page for The Annex explains where foam fits there and where it does not. If your house is in Kensington Market, start with that page. Work on the High Park side of the area has its own page.

Further west, the Runnymede page lists what we do there. We offer the same services in Church and Wellesley and Summerhill, each with its own page. The last one is Forest Hill.

Where foam earns its place

Spray foam insulation in Old Toronto earns its place where one layer has to stop air and hold heat at the same time, and nothing else fits the space. Everywhere else, loose-fill or dense-pack does the job for less, and we tell you that. At Premier Insulation Toronto we decide one part of the house at a time.

Closed-cell foam at the rim joist

If your basement has an open rim joist, closed-cell spray foam seals the gaps at the sill plate and insulates the band in one pass. A batt pushed into a joist pocket leaves air moving behind it. That air carries moisture to the cold wood, and that is how mould starts there.

Foam in sloped ceilings and rafter bays

When a ceiling follows the roofline, each rafter bay is a shallow, closed space. There is no room for a vented layer of loose-fill. Foam sprayed to the underside of the roof deck fills the bay and seals it. In a shallow bay, closed-cell foam is the better pick because it gives more resistance per inch and slows vapour. Open-cell foam costs less and suits deeper bays.

Where loose-fill and dense-pack will do

An open attic floor with room to work takes blown loose-fill, which builds depth for less than foam. Closed wall cavities take dense-pack cellulose. We blow it in through small holes and patch them afterwards, so the wall stays where it is.

Walls, roofs and basements in Old Toronto

If you can reach your attic floor, Attic Insulation builds it up once we have air sealed around the chimney and plumbing stacks. If the existing layer is thin but still dry and sound, Loose-Fill (Blown-In) Insulation goes straight on top. Nothing gets lifted.

If the existing material is damp, flattened or wrecked by animals, Old Insulation Removal comes first. That includes spray foam removal where earlier foam went in badly. We never put new insulation over a layer that has failed.

Roof & Flat Roof Insulation is for a flat-roof addition or a sloped ceiling. The work happens in the rafter bays, and foam is often the only material that fits there. Walls and basements get the same treatment as the rest of the house. We look at that part first, then pick what goes in.

Neighbourhoods we cover in Old Toronto

About Old Toronto: Old Toronto, ON on Wikipedia ยท Old Toronto on Google Maps

FAQ

Insulation questions from Old Toronto

Dufferin, Little Portugal, Brockton, Christie, Parkdale, The Annex, Kensington Market, High Park, Runnymede, Church and Wellesley, Summerhill and Forest Hill. Each has its own page on this site. They are all inside Old Toronto, and we are about 5 km from the middle of it.

Yes, where that part of the house needs it. A rim joist or a shallow rafter bay that has to be sealed and insulated in one layer is a foam job. An open attic or a closed wall cavity can take loose-fill or dense-pack, and those do the job for less, so we use them there. Either way, we look at how the house is built before we quote.

We don't have a Swansea page, so call us with your address and we will tell you straight whether we can take the job. Swansea joined the city in 1967, in the same provincial reform that brought in Forest Hill. The earlier annexations, done by 1893, reached properties west to Swansea, such as High Park.

Get a Quote

Request an insulation visit in Old Toronto

Tell us the address and which part of the house bothers you, whether that is a cold top floor, a drafty basement or a ceiling with no attic above it. Phone or use the form. We'll set up a time to look at the house, then give you a written quote.

Call Text Quote